TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01HV5R

      Remove the 7 clips and cool air intake duct seal.

  2. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01HSG6

      Remove the 2 bolts and inlet air cleaner assembly.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01HTQ5

      Disconnect the mass air flow meter connector and wire harness clamp from the air cleaner cap sub-assembly.

    2. Disconnect the ventilation hose from the cylinder head cover.

    3. Disconnect the connector and wire harness clamp.

    4. A01HSY1

      Release the 2 clamps and remove the air cleaner cap sub-assembly.

    5. A01HVCDE01
      Text in Illustration
      *1 Retainer
      *2 Fuel Tube Connector
      *3 Pipe
      *4 O-ring
      *a Pinch
      *b Pull

      Disconnect the 2 fuel vapor feed hoses.

      Note


      • Remove any dirt or foreign matter on the fuel tube connector before performing this work.

      • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the pipe.

      • Perform this work by hand. Do not use any tools.

      • Protect the disconnected parts by covering them with plastic bags after disconnecting each fuel vapor feed hose.

    6. A01HVR4

      Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.

  4. REMOVE AIR CLEANER FILTER ELEMENT

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01HSNXE03
      Text in Illustration
      *a Projection

      Remove the 2 bolts and air cleaner case sub-assembly.

  6. REMOVE AIRBAG SENSOR ASSEMBLY

    Click here

  7. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

    Note


    • Avoid physical shock to the accelerator pedal sensor assembly.

    • Do not disassemble the accelerator pedal sensor assembly.

    • The accelerator pedal sensor assembly does not require lubrication.

    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.


    1. A01HVZX

      Disconnect the connector.

    2. Remove the 2 bolts and accelerator pedal sensor assembly.

  8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Turn back the floor carpet.

    2. A01HV48

      Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly.

  9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01HVGG

      Disconnect the end of the transmission control cable from the lower shift lever assembly.

    3. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.

    4. A01HW8F

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    5. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.

    6. Remove the clip from the transmission control cable assembly.

    7. A01HV92

      Disconnect the transmission control cable assembly from the 2 transmission control brackets.

    8. A01HTK9E01
      Text in Illustration
      *1 No. 1 parking brake cable assembly
      *2 Transmission control cable assembly

      Remove the bolt and disconnect the No. 1 parking brake cable assembly from the body.

    9. Turn back the dash panel insulator.

    10. Remove the 2 bolts and pull out the transmission control cable assembly from the body.