HYBRID TRANSAXLE SYSTEM ON-VEHICLE INSPECTION


  1. INSPECT FLUID PRESSURE OF OIL PUMP

    Note

    Do the test at normal operating fluid temperature 50 to 80°C (122 to 176°F).


    1. Remove the front fender apron seal LH.

    2. A01HSXH

      Remove the fluid pump cover plug and O-ring from the hybrid vehicle transaxle assembly.

    3. A01HT4YE01

      Install the SST to the hybrid vehicle transaxle assembly.

      SST
      09992-00095   ( 09992-00112, 09992-00271 )
    4. Put the engine in inspection mode Click here.

    5. Measure the fluid pressure.

      Standard
      Engine Speed Transaxle Fluid Pressure
      900 rpm

      9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more

      Note

      Be sure to cancel the inspection mode immediately after the transaxle fluid pressure check is completed.

    6. Remove the SST from the hybrid vehicle transaxle assembly.

    7. Install a new O-ring and fluid pump cover plug to the hybrid vehicle transaxle assembly.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    8. Install the front fender apron seal LH.