VACUUM SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01HUP3

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    1. A01HSOO

      Disconnect the connector.

    2. A01HUZ7

      Disconnect the vacuum hose.

    3. Remove the bolt and manifold absolute pressure sensor.