EGR COOLER INSTALLATION


  1. INSTALL EGR COOLER ASSEMBLY


    1. A01HSYWE01

      Temporarily install 2 new gaskets and the EGR cooler assembly with the bolt (A) and nut (A).

    2. Using an E8 "TORX" socket wrench, install the stud bolt.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    3. Temporarily install the bolt (B) and nut (B).

    4. Temporarily install the 2 bolts (C).

    5. Tighten the 4 bolts and 2 nuts.

      Torque:
      Bolt (A) and Nut (A)
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }
      Bolt (B) and Nut (B)
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }
      Bolt (C)
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that all installation surfaces of the EGR cooler assembly are in even contact when tightening the bolts and nuts.

    6. Connect the water by-pass hose.

  2. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    Click here