REPAIR INSTRUCTION INITIALIZATION


  1. PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

    Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed See page
    Correct the steering angle neutral point Parking assist monitor system

    Click here

    Note


    • After the power switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Navigation Receiver Type)

    • After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Radio and Display Type with Intuitive Parking Assist System)

    • After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 80*1 or 90*2 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Radio and Display Type without Intuitive Parking Assist System)

      *1: w/o Stereo Component Tuner Assembly

      *2: w/ Stereo Component Tuner Assembly

  2. PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

    Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed See page
    ECM Vehicle Identification Number (VIN) registration MIL comes on

    Click here


    • Throttle with motor body assembly

    • Cleaning the deposits from the throttle with motor body assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft

      (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • EGR valve assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair

    • Poor idle, etc.

    • Engine start function, etc

    Click here


    • Door control and tire pressure monitoring system receiver assembly

    • Tire pressure warning valve and transmitter

    		 Transmitter ID registration

    • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

    • Tire pressure warning function

    Click here

    Brake booster with master cylinder assembly

    • Initialization and calibration of the linear solenoid valve

    • Yaw rate and acceleration sensor zero point calibration

    • ABS warning light illumination

    • Brake warning light/yellow (minor malfunction) illumination

    • Slip indicator light illumination

    • VSC disable or malfunctioning

    Click here for Initialization

    Click here for Calibration

    • Brake pedal stroke sensor assembly

    • Brake pedal

    • Clearing stored linear solenoid valve calibration data

    • Initialization and calibration of the linear solenoid valve

    Click here

    Yaw rate and acceleration sensor (airbag sensor assembly)

    • Clearing zero point calibration data

    • Yaw rate and acceleration sensor zero point calibration

    Click here

    Power steering ECU assembly Assist map writing

    • P/S warning light comes on

    • EPS control

    Click here


    • Spiral cable with sensor assembly

    • Spiral cable sub-assembly

    • Steering sensor

    • Correct steering angle neutral point

    • Steering angle setting

    		 Parking assist monitor system

    Click here

    Navigation ECU sub-assembly Navigation ECU sub-assembly initialization

    • Suspension, tires, etc (the vehicle height changes because of suspension or tires replacement)

    • Rear television camera assembly

    		 Back camera position setting
    Blind spot monitor sensor Blind spot monitor beam axis inspection DTCs are output

    Click here


    • Roof console box assembly

    • Garage door opener transmitter

    Re-registration of codes in the garage door opener system


    • Register transmitter code

    • Rolling code systems

    		 Garage door opener system

    Click here

    DCM (Telematics Transceiver) DCM activation Safety connect system

    Click here


    • Certification ECU (smart key ECU assembly)

    • Steering lock ECU (steering lock actuator assembly)

    • Electrical key transmitter sub-assembly

    		 Code registration (Engine immobiliser system)

    • Wireless door lock control system

    • Smart Key system

    • Hybrid control system start

    • Steering lock system

    Click here


    • Occupant detection ECU

    • Front passenger seat

    		 Zero point calibration and sensitivity check. (Occupant classification system)

    • Occupant classification system

    • Passenger airbag ON/OFF indicator

    • Airbag system (Front passenger side)

    • Seat belt warning system (Front passenger)

    Click here


    • No. 1 air conditioning radiator damper servo sub-assembly

    • No. 2 air conditioning radiator damper servo sub-assembly

    • No. 1 blower damper servo sub-assembly

    		 Initialization servo motor (Air conditioning system) DTCs are output

    Click here


    • Door window regulator assembly

    • Power window regulator motor assembly

    • Door glass

    • Door glass run

    		 Initialize power window control system

    • Auto up/down function

    • Jam protection function

    • Operation function after power switch is turned off

    • Key-linked function

    • Wireless transmitter-linked function*1

    Click here


    • Sliding roof ECU (sliding roof drive gear sub-assembly)

    • Sliding roof glass sub-assembly

    • Sliding roof drive cable sub-assembly

    		 Initialize sliding roof ECU (pulse sensor initial position setting)

    • Automatic slide open/close and tilt up/down function of sliding roof

    • Jam protection function

    • Operation function after power switch is turned off

    • Key-linked function

    • Wireless transmitter-linked function*1

    • Sliding roof open warning

    Click here


    • Headlight leveling ECU assembly

    • Rear height control sensor sub-assembly

    		 Perform Headlight leveling ECU initialization Automatic headlight beam level control function

    Click here


    • *1: w/ Daytime Running Light Control