THROTTLE BODY REMOVAL


  1. DRAIN COOLANT (for Engine)

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator cap sub-assembly.

      A01HUK1E01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01HUP3

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01HTQ5

      Disconnect the mass air flow meter connector and wire harness clamp from the air cleaner cap sub-assembly.

    2. Disconnect the ventilation hose from the cylinder head cover.

    3. Disconnect the connector and wire harness clamp.

    4. A01HSY1

      Release the 2 clamps and remove the air cleaner cap sub-assembly.

    5. A01HVCDE01
      Text in Illustration
      *1 Retainer
      *2 Fuel Tube Connector
      *3 Pipe
      *4 O-ring
      *a Pinch
      *b Pull

      Disconnect the 2 fuel vapor feed hoses.

      Note


      • Remove any dirt or foreign matter on the fuel tube connector before performing this work.

      • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the pipe.

      • Perform this work by hand. Do not use any tools.

      • Protect the disconnected parts by covering them with plastic bags after disconnecting each fuel vapor feed hose.

    6. A01HVR4

      Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.

  4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    1. A01HVQK

      Disconnect the 2 hoses.

    2. A01HUCR

      Disconnect the throttle body connector.

    3. Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.

    4. A01HVEC

      Remove the 4 bolts and the throttle body with fuel tube bracket.

    5. A01HUYL

      Remove the gasket from the intake manifold.