SUB RADIATOR REMOVAL


  1. DRAIN COOLANT (for Inverter)

    Note


    • Do not reuse the drained coolant because it may contain foreign objects.

    • Collect the drained coolant and measure its volume to establish a benchmark. When adding coolant, make sure to add more coolant than the measured amount.


    1. Remove the reserve tank cap.

      CAUTION:

      To avoid the danger of being burned, do not remove the reserve tank cap while the coolant for the inverter is still hot.

    2. A01HVNF

      Using a hexagon wrench (10 mm), remove the drain plug indicated in the illustration and drain the coolant.

      CAUTION:

      Use caution when handling coolant immediately after driving or in summer because it may be hot.

    3. Install the plug with a new gasket.

      Torque:
      39 N*m  { 397 kgf*cm, 29 ft.*lbf }

  2. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  3. REMOVE FRONT BUMPER ENERGY ABSORBER


    1. A01HW5J

      Disengage the 2 guides and remove the front bumper energy absorber.

  4. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    1. A01HUSA

      Disengage the 5 clamps.

    2. Remove the 6 bolts and front bumper reinforcement sub-assembly.

  5. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01HSG6

      Remove the 2 bolts and inlet air cleaner assembly.

  6. REMOVE NO. 5 INVERTER BRACKET


    1. A01HV2L

      Remove the 2 bolts and No. 5 inverter bracket.

  7. REMOVE RADIATOR RESERVE TANK ASSEMBLY


    1. A01HTCZ

      Disconnect the radiator reserve tank hose.

    2. Remove the 2 bolts and radiator reserve tank assembly.

  8. REMOVE HOOD LOCK ASSEMBLY


    1. w/ Engine Hood Courtesy Switch:


      1. A01HU7E

        Disconnect the connector.

    2. A01HSTW

      Remove the 3 bolts.

    3. A01HTXS

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  9. REMOVE UPPER RADIATOR SUPPORT


    1. A01HUPO

      Disconnect the 2 connectors.

    2. A01HV9W

      Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.

    3. Remove the 2 radiator support cushions.

  10. REMOVE RADIATOR SIDE DEFLECTOR RH


    1. A01HSIU

      Disengage the 3 claws and remove the radiator side deflector RH.

  11. REMOVE RADIATOR ASSEMBLY


    1. A01HVAO

      Disconnect the 2 water hoses.

      Note

      Put pieces of cloth into the pipes and in the disconnected hoses or cover the pipes and hoses with plastic bags to prevent entry of foreign matter.

    2. A01HT9Y

      Remove the 4 bolts and radiator assembly.