RELAY ON-VEHICLE INSPECTION


  1. INSPECT HORN RELAY (ENGINE ROOM JUNCTION BLOCK ASSEMBLY)


    1. A01EJFHE08
      Text in Illustration
      *a

      Component without harness connected

      (Engine Room Junction Block Assembly)

      Remove the engine room junction block assembly from the engine room relay block Click here.

    2. Connect a positive (+) lead from the battery to terminal 1A-1.

    3. Connect a negative (-) lead from the battery to terminal 1F-7.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      1E-3 - Battery negative Always 11 to 14 V

      If the result is not as specified, replace the engine room junction block assembly.