STOP LIGHT SWITCH INSTALLATION


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A01ELTT

      Insert the stop light switch assembly until the rod hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not depressed.

    2. A01EKHP

      Make a quarter turn clockwise to install the stop light switch assembly.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf, or less }

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not depressed.

    3. Connect the connector.

    4. Check the protrusion of the rod.

      Protrusion of the rod
      1.5 to 2.5 mm (0.0591 to 0.0984 in.)

      If the protrusion is not as specified, adjust it.

      Note

      Do not depress the brake pedal.