REAR COMBINATION LIGHT ASSEMBLY ON-VEHICLE INSPECTION


  1. INSPECT REAR COMBINATION LIGHT ASSEMBLY


    1. A01EKZHE11
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Rear Combination Light Assembly LH)
      *2

      Front view of wire harness connector

      (to Rear Combination Light Assembly RH)

      Disconnect the connector from the rear combination light assembly.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      LH Side
      Tester Connection Condition Specified Condition
      L16-1 - L16-3 Light control switch off Below 1 V
      Light control switch in tail position 11 to 14 V
      L16-2 - L16-3 Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      L16-4 - L16-3 Turn signal switch in neutral position Below 1 V
      Ignition switch ON and turn signal switch in left turn position 11 to 14 V (60 to 120 times per minute)
      RH Side
      Tester Connection Condition Specified Condition
      M11-1 - M11-3 Light control switch off Below 1 V
      Light control switch in tail position 11 to 14 V
      M11-2 - M11-3 Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      M11-4 - M11-3 Turn signal switch neutral position Below 1 V
      Ignition switch ON and turn signal switch in right turn position 11 to 14 V (60 to 120 times per minute)

      If the result is not as specified, repair or replace the wire harness or connector.