HEADLIGHT ASSEMBLY REASSEMBLY


  1. INSTALL FRONT TURN SIGNAL LIGHT BULB


    1. Install the front turn signal light bulb to the front turn signal light socket.

    2. A01EJH3

      Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.

  2. INSTALL DISCHARGE HEADLIGHT BULB


    1. Set the discharge headlight bulb to the headlight unit.

      Note

      Do not touch the bulb glass.

    2. A01EKMIE01

      Lock the set spring to install the discharge headlight bulb as shown in the illustration.

  3. INSTALL LIGHT CONTROL ECU


    1. A01EIVFE01
      Text in Illustration
      *1 Red Line

      Turn the socket of the light control ECU in the direction indicated by the arrow shown in the illustration to connect it.

      Note


      • Check that the O-ring is installed on the light control ECU.

      • Check that the O-ring is not damaged or contaminated with foreign matter. If there is any damage, replace the O-ring with a new one.

      • Do not pull the light control ECU with the socket connected.

    2. Check that the red line on the output harness is not twisted and store the harness in the headlight assembly securely so that the output harness is not pinched.

    3. A01EKK0E01
      Text in Illustration
      *1 Lock Mark

      Turn the light control ECU in the direction indicated by the arrow shown in the illustration until the lock marks are aligned to install it.

      Note


      • To prevent incomplete installation, make sure to fully push in and turn the light control ECU until the lock marks are aligned.

      • Do not apply excessive force using a tool.