LICENSE PLATE LIGHT ASSEMBLY REMOVAL


  1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY


    1. A01EJ5Z

      Disengage the 16 clips and remove the back door panel trim assembly.

  2. REMOVE REAR WIPER ARM HEAD CAP


    1. A01ELMD

      Disengage the 4 claws and remove the rear wiper arm head cap as shown in the illustration.

  3. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


    1. A01EJGA

      Remove the nut and the rear wiper arm and blade assembly.

  4. REMOVE REAR WIPER MOTOR GROMMET


    1. A01EJ00

      Remove the rear wiper motor grommet.

  5. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY


    1. A01EJS5

      Disconnect the connector.

    2. Remove the 3 bolts and the rear wiper motor and bracket assembly.

  6. REMOVE REAR LIGHT ASSEMBLY LH


    1. A01EJKY

      Disconnect the 2 connectors.

    2. Remove the 2 nuts.

    3. A01EISE

      Disengage the 2 pins and remove the rear light assembly.

  7. REMOVE REAR LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  8. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. A01EJTEE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the back door outside garnish sub-assembly.

    2. Disconnect each connector.

    3. A01EL15

      Remove the 5 nuts.

    4. A01EL3R

      Disengage the 16 clips and remove the back door outside garnish sub-assembly.

    5. Remove the 16 clips (back door moulding clip) from the back door outside garnish sub-assembly.

    6. Remove the 5 gaskets and 5 stud bolts from the back door outside garnish sub-assembly.

  9. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    1. A01EMEE

      Disconnect the connector.

    2. Disengage the 2 claws and remove the license plate light assembly.