WASHER NOZZLE (for Rear Side) INSTALLATION


  1. INSTALL REAR WASHER NOZZLE


    1. A01EJQT

      Engage the 2 claws to install the rear washer nozzle.

    2. Connect the washer hose.

  2. INSPECT REAR WASHER NOZZLE


    1. With the engine running, check where the washer fluid hits the windshield.

      A01EJ7YE02
      Standard Measurement
      Area Dimension Area Dimension
      A 134.4 mm (5.29 in.) B 63.5 mm (2.50 in.)
      C 75.4 mm (2.97 in.) D 28.2 mm (1.11 in.)
      E 38.1 mm (1.50 in.) F 120 mm (4.72 in.)
      G 38.7 mm (1.52 in.) H 180.1 mm (7.09 in.)
      Text in Illustration
      *1 Minimum Spray *2 Maximum Spray
      *3 Nominal Spray - -
      OK
      Washer fluid hits the windshield in the area shown in the illustration.

  3. ADJUST REAR WASHER NOZZLE


    1. A01EKAD

      Using a screwdriver, adjust the direction of the rear washer nozzle.

      Note

      Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

      Tech Tips

      Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.

  4. INSTALL REAR SPOILER ASSEMBLY


    1. A01EISR

      Engage the 3 pins to install the rear spoiler assembly.

    2. A01EJON

      Install the 4 bolts.

    3. Install the 2 hole plugs.

    4. Connect the connector.

  5. INSTALL UPPER BACK WINDOW PANEL TRIM


    1. A01EJO5

      Engage the 4 clips and 4 claws to install the upper back window panel trim.