REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY


    1. A01EJS5

      Install the rear wiper motor and bracket assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A01EKISE02
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire surface of the wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A01ELPKE01

      Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Stop the wiper motor at the automatic stop position.

    2. When reusing the rear wiper arm and blade assembly:


      1. A01EM7QE02
        Text in Illustration
        *1 Wiper Arm Serration

        Clean the wiper arm serrations.

    3. When reusing the rear wiper motor and bracket assembly:


      1. A01EJPFE02
        Text in Illustration
        *1 Wire Brush
        *2 Wiper Pivot Serration

        Clean the wiper pivot serrations with a wire brush.

    4. A01EMMCE01
      Text in Illustration
      *1 Ceramic Hard Line

      Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

      Standard Measurement
      Area Dimension
      A 7.5 mm (0.295 in.)
      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

  4. INSTALL REAR WIPER ARM HEAD CAP


    1. A01ELCD

      Engage the 4 claws to install the cap as shown in the illustration.

  5. INSTALL BACK DOOR PANEL TRIM ASSEMBLY


    1. A01EJ5Z

      Engage the 16 clips and install the back door panel trim assembly.