POWER MIRROR CONTROL SYSTEM Reverse Shift-linked Function of Power Mirrors does not Operate

SYSTEM DESCRIPTION

On receiving a reverse signal from the park/neutral position switch assembly, the ECM sends the reverse signal to the main body ECU (driver side junction block assembly) via CAN communication. When receiving the reverse signal, the main body ECU (driver side junction block assembly) sends the reverse request signal to each outer mirror control ECU. Each outer mirror control ECU then performs control in response to the reverse signal.

Tech Tips

The reverse shift-linked function will not activate when the mirror select switch is in the neutral position (off).

WIRING DIAGRAM

A01EKE0E27

INSPECTION PROCEDURE

Tech Tips

The reverse shift-linked function will not activate when the mirror select switch is in the neutral position (off).

PROCEDURE


  1. CHECK MEMORY AND REACTIVATION FUNCTION


    1. A01EK6EE01
      Text in Illustration
      *a Turn to Left Fully

      Turn the ignition switch ON.

    2. Using the outer mirror switch assembly, turn the mirror surface to the fully left position.

    3. Press the M1 switch while the SET switch is being pressed.

    4. Check that the buzzer sounds for 0.5 seconds and the mirror surface position is memorized.

    5. Using the outer mirror switch assembly, turn the mirror surface to the fully right position.

    6. Press the M1 switch.

    7. Check that the buzzer sounds for 0.1 seconds and the outer mirror automatically moves to the recorded fully left position.

      Result
      Result Proceed to
      Memory and reactivation functions are normal. A
      Memory function is not normal. B
      Reactivation function is not normal. C

    B

    GO TO OTHER DIAGNOSIS PROCEDURE (Power Mirror Surface Position is not Memorized) Click here

    C

    GO TO OTHER DIAGNOSIS PROCEDURE (Power Mirrors do not Return to Memorized Position) Click here

    A

  2. CHECK CAN COMMUNICATION SYSTEM


    1. Use the GTS to check if the CAN communication system is functioning normally Click here.

      OK
      CAN communication DTC is not output.

    NG

    GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

    OK

  3. CHECK FOR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / DTC.

    5. Check if SFI system DTCs are output.

      OK
      SFI system DTCs are not output.

    NG

    GO TO SFI SYSTEM (for 1AR-FE) (DIAGNOSTIC TROUBLE CODE CHART) Click here

    OK

  4. CHECK COMBINATION METER ASSEMBLY


    1. Check if the shift position indicator light in the combination meter assembly operates normally.

      OK
      The shift position indicator light indicates the actual shift position correctly.

    NG

    GO TO METER / GAUGE SYSTEM (PROBLEM SYMPTOMS TABLE) Click here

    OK

  5. CHECK REVERSE SHIFT-LINKED FUNCTION


    1. A01EKYRE01
      Text in Illustration
      *a Downward

      Turn the ignition switch ON.

    2. Set the mirror select switch to L or R.

    3. Check that the mirror surface turns downward when the shift lever is moved to R.

      Result
      Result Proceed to
      Reverse shift-linked functions on both mirrors are not normal A
      Reverse shift-linked function on driver door is not normal B
      Reverse shift-linked function on front passenger door is not normal C

    B

    REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) Click here

    C

    REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (FRONT PASSENGER DOOR) Click here

    A

    REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) Click here