POWER BACK DOOR CONTROL SWITCH INSPECTION


  1. INSPECT POWER BACK DOOR CONTROL SWITCH

    A01EK1NE03

    1. Measure the resistance of the switch.

      Standard resistance
      Tester Connection Condition Specified Condition
      1(E) - 4(CSW) Pushed (ON) Below 1 Ω
      1(E) - 4(CSW) Free (OFF) 10 kΩ or higher

      If the result is not as specified, replace the switch.

    2. Check that the switch illuminates.

      Standard resistance
      Measurement Condition Specified Condition

      Battery positive (+) → 3 (ILL+)

      Battery negative (-) → 2 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the switch.