BACK DOOR OPENER SWITCH INSPECTION


  1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


    1. Check operation of the opener switch.


      1. Measure the resistance according to the value(s) in the table below.

        A01EK2JE23
        Standard resistance
        Tester Connection Switch Position Specified Condition
        2(E) - 3(UL) Back door opener switch not pushed (OFF) 10 kΩ or higher
        2(E) - 3(UL) Back door opener switch pushed (ON) Below 1 Ω

        If the result is not specified, replace the back door opener switch assembly.

    2. Check operation of the lock switch (w/ Smart Entry and Start System).


      1. A01ELGLE02

        Measure the resistance according to the value(s) in the table below.

        Standard resistance
        Tester Connection Switch Position Specified Condition
        1(L) - 2(E) Back door lock switch not pushed (OFF) 10 kΩ or higher
        1(L) - 2(E) Back door lock switch pushed (ON) Below 1 Ω

        If the result is not specified, replace the back door opener switch assembly.