SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)

    A01EMI5E01
    Text in Illustration
    *1

    Component without harness connected

    Sliding Roof Switch (Roof Console Box Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      P6-4 (DOWN) - P6-1 (GND) TILT DOWN switch is pressed Below 1 Ω
      P6-4 (DOWN) - P6-1 (GND) TILT DOWN switch is not pressed 10 kΩ or higher
      P6-5 (UP) - P6-1 (GND) TILT UP switch is pressed Below 1 Ω
      P6-5 (UP) - P6-1 (GND) TILT UP switch is not pressed 10 kΩ or higher
      P6-2 (CLS) - P6-1 (GND) SLIDE CLOSE switch is pressed Below 1 Ω
      P6-2 (CLS) - P6-1 (GND) SLIDE CLOSE switch is not pressed 10 kΩ or higher
      P6-3 (OPN) - P6-1 (GND) SLIDE OPEN switch is pressed Below 1 Ω
      P6-3 (OPN) - P6-1 (GND) SLIDE OPEN switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (roof console box assembly).