FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Click here.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE


    1. A01ELE9

      Disengage the 3 clips, 7 claws and guide, and remove the front door scuff plate LH.

  3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. A01EKTQ

      Remove the rear part of the front door opening trim weatherstrip to the extent that allows removal of the lower center pillar garnish and center pillar garnish.

  4. REMOVE REAR DOOR SCUFF PLATE


    1. A01EMQ6

      Disengage the 2 clips and 6 claws, and remove the rear door scuff plate LH.

  5. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. A01EKIO

      Remove the front part of the rear door opening trim weatherstrip to the extent that allows removal of the lower center pillar garnish and center pillar garnish.

  6. REMOVE LAP BELT OUTER ANCHOR COVER


    1. A01EJOK

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01EL5J

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  8. REMOVE LOWER CENTER PILLAR GARNISH


    1. A01EJER

      Disengage the 2 claws, guide and 2 clips, and remove the lower center pillar garnish LH as shown in the illustration.

  9. REMOVE UPPER CENTER PILLAR GARNISH


    1. A01ELOD

      Remove the screw.

    2. Using a clip remover, disengage the clip.

    3. Pass the floor anchor of the front seat outer belt assembly LH through the upper center pillar garnish LH and remove the upper center pillar garnish LH.

  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01EMEA

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A01EM4P

      Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01EMMJ

      Remove the bolt.

    4. Disengage the 2 guides and remove the front seat outer belt assembly.

  11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01EKQG

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.