SEAT BELT WARNING SYSTEM Driver Side Seat Belt Warning Light does not Operate

DESCRIPTION

When the ignition switch is ON, the center airbag sensor assembly transmits front seat inner belt status signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver side seat belt warning light. If the seat belt is fastened, the warning light goes off.

WIRING DIAGRAM

A01EMJGE24

INSPECTION PROCEDURE

Note

The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure Click here.

PROCEDURE


  1. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)


    1. Clear the DTC Click here.

    2. Recheck for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  2. CHECK DTC OUTPUT (AIRBAG SYSTEM)


    1. Clear the DTC Click here.

    2. Recheck for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    GO TO AIRBAG SYSTEM Click here

    A

  3. PERFORM ACTIVE TEST USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Combination Meter (Combination Meter Assembly)
      Tester Display Test Part Control Range Diagnostic Note
      Driver Side Seat Belt Driver side seat belt warning light OFF or ON Confirm that the vehicle stopped with the engine idling
      OK
      The driver side seat belt warning light on the combination meter assembly operates normally.

    NG

    REPLACE COMBINATION METER ASSEMBLY Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here