SEAT HEATER CONTROL REMOVAL


  1. REMOVE FRONT SEAT HEADREST ASSEMBLY

  2. REMOVE FRONT SEAT REAR OUTER TRACK COVER


    1. Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.

    2. A01EK4X

      Disengage the 2 claws and remove the front seat rear outer track cover.

  3. REMOVE FRONT SEAT REAR INNER TRACK COVER


    1. A01EKMV

      Disengage the 2 claws and remove the front seat rear inner track cover.

  4. REMOVE FRONT SEAT ASSEMBLY


    1. A01ELZQ

      Remove the 2 bolts on rear side of the front seat assembly.

    2. Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.

    3. A01ELJK

      Remove the 2 bolts on front side of the front seat assembly.

    4. Operate the slide and vertical power seat switch knob and move the front seat assembly to the center position. Also, operate the reclining power seat switch knob and move the front seatback assembly to the upright position.

    5. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    6. Disconnect each connector under the front seat assembly.

    7. Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.

  5. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY


    1. A01EIR3

      Disconnect the connector.

    2. Disengage the clamp and remove the seat heater control sub-assembly.