SEAT HEATER CONTROL INSTALLATION


  1. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY


    1. A01EIR3

      Engage the clamp and install the seat heater control sub-assembly.

    2. Connect the connector.

  2. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector under the front seat assembly.

    3. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    6. A01ELJKE01

      Tighten the 2 bolts on front side of the front seat assembly.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

    7. Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.

    8. A01ELZQE01

      Tighten the 2 bolts on rear side of the front seat assembly.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

  3. INSTALL FRONT SEAT REAR INNER TRACK COVER


    1. A01EKMV

      Engage the 2 claws to install the front seat rear inner track cover.

  4. INSTALL FRONT SEAT REAR OUTER TRACK COVER


    1. A01EK4X

      Engage the 2 claws to install the front seat rear outer track cover.

  5. INSTALL FRONT SEAT HEADREST ASSEMBLY

  6. INSPECT FRONT SEAT ASSEMBLY


    1. Inspect the power seat operation.

    2. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  7. INSPECT SRS WARNING LIGHT

    Click here