SEAT POSITION SENSOR INSTALLATION


  1. INSTALL SEAT POSITION SENSOR


    1. A01EMR4

      Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.

    2. A01EINYE11
      Text in Illustration
      *1 Seat Position Sensor
      *2 Feeler Gauge
      *3 Seat Rail

      Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor.

      Note


      • If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.

      • When installing the seat position sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

      Tech Tips

      Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

    3. A01EJ44

      Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position sensor.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

    5. Connect the connector.

    6. Check that there is no looseness in the installation parts of the seat position sensor.

  2. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.

  4. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.