DRIVE MONITOR SWITCH INSPECTION


  1. INSPECT DRIVE MONITOR SWITCH

    A01EJDLE10
    Text in Illustration
    *1

    Component without harness connected

    (Drive Monitor Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (E) - 5 (INFO) INFO switch is pressed Below 1 Ω
      INFO switch is released 10 kΩ or higher
      3 (E) - 6 (SEL) SELECT RESET switch is pressed Below 1 Ω
      SELECT RESET switch is released 10 kΩ or higher
      3 (E) - 7 (STUP) SETUP switch is pressed Below 1 Ω
      SETUP switch is released 10 kΩ or higher

    2. Apply battery voltage from the wire harness back side between the terminals of the switch, and check the lighting condition of the drive monitor switch.

      OK
      Measurement Condition Condition Specified Condition

      Battery negative (-) → 1 (ILL-)

      Battery positive (+) → 8 (ILL+)

      		 Always Drive monitor switch illuminates

      Tech Tips

      If the result is not as specified, replace the drive monitor switch Click here.