ELECTRICAL KEY OSCILLATOR (for Rear Side) INSTALLATION


  1. INSTALL ELECTRICAL KEY ANTENNA


    1. A01ELSX

      Install the electrical key antenna with the 2 nuts.

      Note

      Be careful when installing the electrical key antenna. If the antenna is dropped, replace it with a new one.

    2. Connect the connector.

  2. INSTALL REAR BUMPER ASSEMBLY


    1. Connect each connector.

    2. A01EK9D

      Engage the 6 claws to install the rear bumper assembly as shown in the illustration.

    3. A01ELHK

      Engage the 5 claws.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. Install the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. Engage the 2 clips and install the 2 screws.

    6. Install the 2 bolts and 2 screws.

      Torque:
      Bolt
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    7. Engage the 2 clips.

  3. INSTALL REAR BUMPER PLATE LH


    1. A01EM2S

      Engage the 2 claws to install the rear bumper plate LH.

  4. INSTALL REAR BUMPER PLATE RH

    Tech Tips

    Use the same procedure for the RH side and LH side.