WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Entry and Start System) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.

      Main Body (Main Body ECU (Driver Side Junction Block Assembly))
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Wireless Control Wireless door lock control function/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Hazard Answer Back Hazard answer-back of wireless/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Wireless Auto Lock Automatic lock function / ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Open Door Warning* Open door warning/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Unlock 2 Operation 2 times operation of wireless unlock / ON or OFF

      ON: All doors unlock when UNLOCK switch pressed twice

      OFF: All doors unlock when UNLOCK switch pressed once

      		 -
      Auto Lock Time Automatic lock time/120 s, 60 s or 30 s

      120 s: 120 seconds

      60 s: 60 seconds

      30 s: 30 seconds

      		 -
      Wireless Buzz Vol Wireless buzzer volume / LEVEL0 to LEVEL7

      Level7: Biggest volume

      Level6

      Level5

      Level4

      Level3

      Level2

      Level1: Smallest volume

      Level0: No sound

      		 -

      • *: w/ Door Ajar Warning Buzzer Function

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body or Entry&Start / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Main Body (Main Body ECU (Driver Side Junction Block Assembly))
      Tester Display Test Part Control Range Diagnostic Note
      Hazard Turns the turn signal flasher relay ON/OFF Observe headlight and rear combination light for correct operation
      Illuminated Entry System Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed) ON/OFF -