POWER DOOR LOCK CONTROL SYSTEM All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch

DESCRIPTION

The main body ECU (driver side junction block assembly) receives switch signals from the door control switch and activates the door lock motor on each door according to these signals.

WIRING DIAGRAM

A01EMRTE05

INSPECTION PROCEDURE

PROCEDURE


  1. READ VALUE USING GTS (DOOR CONTROL SWITCH)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.

      Main Body (Main Body ECU (Driver Side Junction Block Assembly))
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Door Lock SW-Lock Front passenger side door control switch lock signal/ON or OFF

      ON: Front passenger side door control switch pushed to lock position

      OFF: Front passenger side door control switch not pushed to lock position

      		 -
      Door Lock SW-Unlock Front passenger side door control switch unlock signal/ON or OFF

      ON: Front passenger side door control switch pushed to unlock position

      OFF: Front passenger side door control switch not pushed to unlock position

      		 -
      OK
      On the GTS screen, ON or OFF will be displayed accordingly.

    NG

    INSPECT DOOR CONTROL SWITCH ASSEMBLY Click here

    OK

    REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) Click here

  2. INSPECT DOOR CONTROL SWITCH ASSEMBLY


    1. A01ELX2E01
      Text in Illustration
      *1

      Component without harness connected

      (Door Control Switch Assembly)
      *2 Unlock
      *3 Lock

      Remove the door control switch assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      4 (L) - 3 (E) Lock Below 1 Ω
      4 (L) - 3 (E) Off 10 kΩ or higher
      2 (UL) - 3 (E) Unlock Below 1 Ω
      2 (UL) - 3 (E) Off 10 kΩ or higher

    NG

    REPLACE DOOR CONTROL SWITCH ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH - MAIN BODY ECU AND BODY GROUND)


    1. A01EJXBE01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Door Control Switch Assembly)
      *2

      Front view of wire harness connector

      (to Main Body ECU (Driver Side Junction Block Assembly))

      Disconnect the 2J driver side junction block connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H6-2 (UL) - 2J-4 (UL1) Always Below 1 Ω
      H6-4 (L) - 2J-3 (L1) Always Below 1 Ω
      H6-3 (E) - Body ground Always Below 1 Ω
      H6-2 (UL) - Body ground Always 10 kΩ or higher
      H6-4 (L) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) Click here