CAN COMMUNICATION SYSTEM Navigation Receiver Assembly Communication Stop Mode

DESCRIPTION

Detection Item Symptom Trouble Area
Navigation Receiver Assembly Communication Stop Mode

  • "Display and Navigation (AVN1)" is not displayed on the "CAN Bus Check" screen of the GTS.

  • Applies to Navigation Receiver Assembly Communication Stop Mode in DTC Combination Table.

  • Power source circuit of navigation receiver assembly

  • Navigation receiver assembly branch wire or connector

  • Navigation receiver assembly

WIRING DIAGRAM

A01EJFNE07

INSPECTION PROCEDURE

Note


  • Turn the ignition switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.

  • Turn the ignition switch off before inspecting CAN bus wires for a ground short.

  • After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.

  • Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

Tech Tips


  • Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

  • Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE


  1. CHECK FOR OPEN IN CAN BUS WIRES (NAVIGATION RECEIVER ASSEMBLY BRANCH WIRE)


    1. Turn the ignition switch off.

    2. A01ELRIE48
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Navigation Receiver Assembly)

      Disconnect the navigation receiver assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E40-9 (CANH) - E40-10 (CANL) Ignition switch off 54 to 69 Ω

    NG

    REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (NAVIGATION RECEIVER ASSEMBLY BRANCH WIRE)

    OK

  2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    1. A01ELS7E35
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Navigation Receiver Assembly)

      Disconnect the navigation receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E38-4 (+B1) - Body ground Always 11 to 14 V
      E38-3 (ACC1) - Body ground Ignition switch ACC 11 to 14 V
      E40-1 (IG) - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE TERMINAL)

    OK

  3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    1. A01EJ6QE03
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Navigation Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E38-7 (GND1) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND TERMINAL)

    OK

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here