GENERATOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EJEH

      Remove the 12 clips and cool air intake duct seal.

  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  4. REMOVE V-RIBBED BELT

    Tech Tips

    Click here

  5. REMOVE WIRE HARNESS CLAMP BRACKET

    A01EL0K

    1. Detach the wire harness clamp from the clamp bracket.

    2. Remove the bolt and clamp bracket.

  6. REMOVE GENERATOR ASSEMBLY


    1. A01EJ6Z

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the generator wire.

    4. Remove the bolt and wire harness clamp bracket.

    5. A01ELME

      Remove the 2 bolts and generator.