REAR VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the rear view monitor system.

  • *: Use the GTS.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  3. PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs B

    B

    Go to step 5
    A

  4. SYMPTOM SIMULATION


    NEXT

  5. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM


    1. Refer to the navigation system (for Navigation Receiver Type) Click here.*1

    2. Refer to the navigation system (for Radio and Display Type) Click here.*2

    3. Refer to the audio and visual system Click here.*3


      • *1: for Navigation Receiver Type

      • *2: for Radio and Display Type (w/ Navigation System)

      • *3: for Radio and Display Type (w/o Navigation System)

      Result
      Result Proceed to
      Symptom does not occur A
      Symptom appears (navigation system (for Navigation Receiver Type)) B
      Symptom appears (navigation system (for Radio and Display Type)) C
      Symptom appears (audio and visual system) D

      B

      GO TO NAVIGATION SYSTEM (for Navigation Receiver Type) Click here

      C

      GO TO NAVIGATION SYSTEM (for Radio and Display Type) Click here

      D

      GO TO AUDIO AND VISUAL SYSTEM Click here

      A

  6. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally Click here.

      Result
      Result Proceed to
      CAN communication system DTCs are not output (for Navigation Receiver Type) A
      CAN communication system DTCs are not output (for Radio and Display Type) B
      CAN communication system DTCs are output C

      B

      Go to step 8
      C

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  7. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note

      The navigation receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

      System Proceed to
      Navigation System (for Navigation Receiver Type)

      Click here

      Result
      Result Proceed to
      No DTCs are output. A
      Rear view monitor system DTCs are output. B
      Navigation system DTCs are output. C

      B

      Go to step 10
      C

      GO TO NAVIGATION SYSTEM Click here

      A

  8. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 10
      A

  9. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM


    1. Terminals of ECU Click here.


      NEXT

  10. ADJUST, REPAIR OR REPLACE


    NEXT

  11. CONFIRMATION TEST


    NEXT
    END