NAVIGATION SYSTEM (for Radio and Display Type) Navigation Voice Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or the voice switch of the steering pad switch is pushed.

Using this circuit, the extension module sends signals to the stereo component amplifier assembly via the radio and display receiver assembly.

WIRING DIAGRAM

A01EIZ4E15

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the E5 radio and display receiver assembly connector.

    2. Disconnect the E14 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester connection Condition Specified condition
      E5-2 (RL+) - E14-15 (II1+) Always Below 1 Ω
      E5-6 (RL-) - E14-14 (II1-) Always Below 1 Ω
      E14-18 (SLD1) - Body ground Always 10 kΩ or higher
      E14-15 (II1+) - Body ground Always 10 kΩ or higher
      E14-14 (II1-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here