NAVIGATION SYSTEM (for Radio and Display Type) Data Signal Circuit between Stereo Jack Adapter and Extension Module

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the extension module via this circuit.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (EXTENSION MODULE - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

   
   

   1. Disconnect the E50 extension module connector.

   2. Disconnect the E36 No. 1 stereo jack adapter assembly connector.

   3. 

      Text in Illustration

      *a	Front view of wire harness connector (to Extension Module)
      *b	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition E36-2 (UDO-) - E50-2 (UDO-) Always Below 1 Ω E36-3 (UDO+) - E50-3 (UDO+) Always Below 1 Ω E36-5 (UJSS) - E50-5 (USG1) Always Below 1 Ω E36-2 (UDO-) - Body ground Always 10 kΩ or higher E36-3 (UDO+) - Body ground Always 10 kΩ or higher E36-5 (UJSS) - Body ground Always 10 kΩ or higher

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here