STEERING COLUMN ASSEMBLY INSPECTION


  1. INSPECT PRELOAD


    1. A01EK7OE01
      Text in Illustration
      *1 Service Nut
      *2 Steering Wheel Assembly Set Nut

      Secure the steering column assembly in a vise.

      Note

      When using a vise, do not overtighten it.

    2. Install a service nut to the steering main shaft.

      Recommended service nut
      Thread diameter
      12.0 mm (0.472 in.)
      Thread pitch
      1.25 mm (0.0492 in.)

    3. Install the steering wheel assembly set nut to the steering main shaft.

    4. Lock the steering wheel assembly set nut using the service nut.

    5. Using a torque wrench, turn the main shaft and measure the preload.

      Torque:
      Preload
      0.98 to 1.58 N*m  { 10 to 16 kgf*cm, 9 to 13 in.*lbf }

      If the preload is not as specified, replace the steering column assembly.

  2. INSPECT STEERING LOCK OPERATION (w/o Smart Entry and Start System)


    1. A01EJ3XE01

      Check that the steering lock mechanism is activated when the key is removed.

    2. A01ELN7E01

      Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

      Tech Tips

      If there is any abnormality, replace the ignition switch lock cylinder assembly or steering column upper bracket assembly.