BRAKE PEDAL LOAD SENSING SWITCH ON-VEHICLE INSPECTION


  1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH

    Note


    • Do not remove the brake pedal load sensing switch from the brake pedal support assembly.

    • When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.


    1. Disconnect the brake pedal load sensing switch connector.

      A01EKEZE01

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (FSW+) - 1 (GND) Brake pedal load sensing switch OFF (Brake pedal depressed) 950 to 1050 Ω
      2 (FSW+) - 1 (GND) Brake pedal load sensing switch ON (Brake pedal released) 203 to 223 Ω

      If the value is not as specified, replace the brake pedal support assembly Click here.