PROPELLER SHAFT ASSEMBLY REASSEMBLY


  1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    1. A01ELPRE03

      Set the No. 1 center support bearing on the intermediate shaft as shown in the illustration.

      Note

      Make sure to install the bearing in the correct position.

    2. Install a new washer to the intermediate shaft.

    3. A01EIYCE02
      Text in Illustration
      *1 Matchmark

      Align the matchmarks on the universal joint flange and intermediate shaft and place the flange on the shaft.

    4. A01EJ2KE04
      Text in Illustration
      *1 Turn
      *2 Hold

      Using SST to hold the universal joint flange, press the No. 1 center support bearing assembly into position by tightening a new nut and washer.

      SST
      09330-00021
      Torque:
      182 N*m  { 1851 kgf*cm, 134 ft.*lbf }

    5. Loosen the nut.

    6. Tighten the nut again.

      Torque:
      69 N*m  { 701 kgf*cm, 51 ft.*lbf }
    7. A01EMHY

      Using a chisel and a hammer, stake the nut.

  2. INSTALL NO. 2 CENTER SUPPORT BEARING ASSEMBLY


    1. A01EIPZE02

      Set the No. 2 center support bearing on the intermediate shaft as shown in the illustration.

      Note

      Make sure to install the bearing in the correct position.

    2. Install a new washer to the intermediate shaft.

    3. A01EL0GE02
      Text in Illustration
      *1 Matchmark

      Align the matchmarks on the universal joint flange and intermediate shaft, and place the flange on the shaft.

    4. A01EKCPE03
      Text in Illustration
      *1 Turn
      *2 Hold

      Using SST to hold the universal joint flange, press the No. 2 center support bearing assembly into position by tightening a new nut and washer.

      SST
      09330-00021
      Torque:
      182 N*m  { 1851 kgf*cm, 134 ft.*lbf }

    5. Loosen the nut.

    6. Tighten the nut again.

      Torque:
      69 N*m  { 701 kgf*cm, 51 ft.*lbf }
    7. A01ELUP

      Using a chisel and a hammer, stake the nut.

  3. INSTALL INTERMEDIATE SHAFT


    1. A01EIO7E01
      Text in Illustration
      *1 Matchmark

      Align the matchmarks on the intermediate shaft and rear propeller shaft, and then install 2 washers and 6 bolts.

    2. Using a hexagon wrench (6 mm), tighten the 6 bolts with 2 washers temporarily.

  4. INSTALL PROPELLER SHAFT


    1. Align the matchmarks on the propeller shaft and the universal joint flange.

    2. A01ELQ8E01
      Text in Illustration
      *1 Matchmark

      Install the propeller shaft to the front flange with the 4 bolts, 4 washers and 4 nuts.

      Torque:
      74 N*m  { 750 kgf*cm, 55 ft.*lbf }

      Note


      • Install the washers between the bolts and the propeller shaft.

      • Do not allow grease to adhere to the bolts, washers, or nuts.

    3. Check that each joint of the propeller with center bearing shaft assembly is facing the direction shown in the illustration.

      A01EJE8