REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 12 clips and cool air intake duct seal.
REMOVE INLET AIR CLEANER ASSEMBLY
Remove the 2 bolts and inlet air cleaner assembly.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter connector and separate the wire harness clamp from the air cleaner cap.
Separate the hose from the hose clamp.
Disconnect the ventilation hose from the cylinder head cover.
Unlock the hose band and separate the air cleaner cap sub-assembly from the throttle body assembly.
Remove the 2 bolts and air cleaner cap sub-assembly.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Remove the air cleaner filter element sub-assembly.
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Disconnect the wire harness clamp.
Remove the 3 bolts and air cleaner case sub-assembly.
REMOVE AIR CLEANER BRACKET
Separate the wire harness clamp.
Remove the 2 bolts and air cleaner bracket.
REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Remove the clip from the transmission control cable bracket.
Remove the nut and transmission control cable from the control shaft lever.
Disconnect the connector from the park/neutral position switch.
Remove the nut, washer and control shaft lever from the control shaft.
Remove the 2 bolts and park/neutral position switch from the control shaft.
Note
Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.