SPEED SENSOR REMOVAL


  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

    Tech Tips

    See the steps from "Remove Engine Assembly with Transaxle" through "Remove Automatic Transaxle Assembly" Click here.

  2. REMOVE TORQUE CONVERTER ASSEMBLY

  3. REMOVE TRANSFER ASSEMBLY


    1. A01EM89

      Remove the 2 bolts and 6 nuts.

    2. Using a plastic hammer, remove the transfer assembly from the automatic transaxle assembly.

      Note


      • Remove the transfer assembly from the automatic transaxle assembly without tilting it.

      • During removal, do not hold the transfer assembly by the oil seals on either side of the assembly.

  4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    1. A01ELPH

      Remove the 19 bolts and oil pan from the transaxle.

      Note

      Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan sub-assembly.

    2. Remove the gasket from the oil pan.

    3. A01EIVRE02
      Text in Illustration
      *1 Magnet

      Remove the 2 magnets from the oil pan.

    4. A01ELLJ

      Examine particles in the oil pan.


      1. Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the oil pan and on the magnets to see the type of wear which might be found in the transaxle.

        Result
        Steel (magnetic)
        Bearing, gear and plate wear
        Brass (non-magnetic)
        Bushing wear

  5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A01EJOJ

      Remove the 2 bolts and oil strainer from the valve body.

    2. A01EIPOE02
      Text in Illustration
      *1 O-ring

      Remove the O-ring from the oil strainer.

  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    1. A01EKRR

      Remove the 11 bolts and valve body from the transaxle.

      Note

      When removing the transmission valve body assembly, be careful not to allow the speed sensor and the transaxle case to interfere with each other.

  7. REMOVE SPEED SENSOR


    1. Disconnect the connector.

    2. A01EL8Z

      Remove the 2 bolts and speed sensor from the valve body.