STARTER REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EJEH

      Remove the 12 clips and cool air intake duct seal.

  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  4. REMOVE BATTERY


    1. A01ELF9

      Remove the nut and separate the positive (+) battery terminal.

    2. Loosen the nut and remove the bolt and battery clamp.

    3. Remove the battery and battery tray.

  5. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01EKOK

      Remove the 2 bolts and inlet air cleaner assembly.

  6. REMOVE STARTER ASSEMBLY


    1. A01EK2A

      Disconnect the starter connector.

    2. Open the terminal cap, remove the nut and disconnect the starter wire.

    3. A01EL88

      Remove the 2 bolts and starter.