RELAY ON-VEHICLE INSPECTION


  1. FAN NO. 1 RELAY


    1. A01EKWVE01

      Remove the relay from the engine room relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied between terminals 1 and 2 Below 1 Ω

      • If the result is not as specified, replace the relay.

    3. Install the relay to the engine room relay block.

  2. FAN NO. 2 RELAY


    1. A01EKI6E01

      Remove the relay from the engine room relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Battery voltage is not applied between terminals 1 and 2 Below 1 Ω
      3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 4 Battery voltage is applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied between terminals 1 and 2 Below 1 Ω

      • If the result is not as specified, replace the relay.

    3. Install the relay.

  3. FAN NO. 3 RELAY


    1. A01EKWVE45

      Remove the relay from the engine room relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied between terminals 1 and 2 Below 1 Ω

      • If the result is not as specified, replace the relay.

    3. Install the relay.