WATER PUMP ON-VEHICLE INSPECTION


  1. REMOVE FRONT WHEEL RH

  2. REMOVE NO. 1 ENGINE UNDER COVER

  3. SEPARATE FRONT FENDER LINER RH

  4. REMOVE FRONT FENDER APRON RH


    1. A01EITO

      Remove the 2 bolts, clip and front fender apron seal RH.

  5. REMOVE V-RIBBED BELT


    1. A01EKX6

      Attach a wrench to the hexagonal portion of the belt tensioner as shown in the illustration, rotate the belt tensioner clockwise, and remove the V-ribbed belt.

  6. INSPECT WATER PUMP ASSEMBLY


    1. Visually check the drain hole for coolant leakage.

      If leakage is found, replace the water pump assembly.

    2. A01ELGU

      Turn the pulley and check that the water pump bearing moves smoothly without making a clicking noise.

      If the bearing does not move smoothly, replace the water pump assembly.

  7. INSTALL V-RIBBED BELT


    1. A01EJPME03
      Text in Illustration
      *1 Generator
      *2 Tensioner
      *3 Crankshaft
      *4 Water Pump
      *5 Cooler Compressor

      Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.

    2. Loosen the V-ribbed belt by turning the belt tensioner clockwise.

    3. Set the V-ribbed belt onto the water pump pulley.

      Note

      Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

  8. INSTALL FRONT FENDER APRON RH


    1. A01EITO

      Install the front fender apron seal RH with the 2 bolts and clip.

  9. INSTALL FRONT FENDER LINER RH

  10. INSTALL NO. 1 ENGINE UNDER COVER

  11. INSTALL FRONT WHEEL RH