DISCHARGE FUEL SYSTEM PRESSURE
Discharge fuel system pressure Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR SEAT ASSEMBLY LH
Remove the rear seat assembly LH Click here.
REMOVE REAR SEAT ASSEMBLY RH
Remove the rear seat assembly RH Click here.
REMOVE REAR FLOOR SERVICE HOLE COVER
Turn over the rear floor carpet and the rear floor silencer.
Remove the service hole cover and disconnect the fuel pump connector.
REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | Fuel Tube |
| *4 | O-ring |
| *5 | Fuel Suction Plate |
Remove the tube joint clip, and pull out the fuel pump tube.
Note
Before removing the tube joint clip, check for foreign matter around the clip. Clean it if necessary.
Keep the O-rings free of foreign matter, as they become contaminated easily.
Do not use any tools in this procedure.
Do not forcibly bend or twist the tube.
Put the tube in a plastic bag to prevent damage and contamination.
If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
Be careful not to damage the clip. If the clip is damaged, replace it.
Remove the 8 bolts and the fuel tank vent tube set plate.
Tech Tips
While holding the fuel suction tube by hand, remove the fuel tank vent tube set plate.
Disconnect the clip and fuel tube.
Remove the fuel suction tube assembly with pump and gauge from the fuel tank.
Note
Make sure that the sender gauge arm does not bend.
Do not damage the fuel suction tube.
Remove the fuel suction tube set gasket from the fuel tank.