HEATED OXYGEN SENSOR INSTALLATION


  1. INSTALL HEATED OXYGEN SENSOR


    1. A01EKCGE01
      Text in Illustration
      *1

      Fulcrum Length

      30 mm
      *2

      Fulcrum Length

      300 mm

      Using SST, install the heated oxygen sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. A01EIO2

      Connect the heated oxygen sensor connector.

    3. A01ELTI

      Install the wire harness to wire harness clamp.

  2. INSPECT FOR EXHAUST GAS LEAK

  3. INSTALL NO. 2 ENGINE UNDER COVER

  4. INSTALL NO. 1 ENGINE UNDER COVER