AIR FUEL RATIO SENSOR INSTALLATION


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A01EKHCE01
      Text in Illustration
      *1

      Fulcrum Length

      30 mm
      *2

      Fulcrum Length

      300 mm

      Using SST, install the air fuel ratio sensor to the exhaust manifold.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. A01ELYB

      Connect the air fuel ratio sensor connector.

    3. Install the wire harness clamp.

  2. INSPECT FOR EXHAUST GAS LEAK

  3. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01EIRR

      Install the No. 1 exhaust manifold heat insulator with the 4 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  4. INSTALL INLET AIR CLEANER ASSEMBLY


    1. A01EKOK

      Install the inlet air cleaner assembly with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  5. INSTALL COOL AIR INTAKE DUCT SEAL


    1. A01EJEH

      Install the cool air intake duct seal with the 12 clips.

  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Fit the 3 retainers and install the No. 1 engine cover sub-assembly.