AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EJEH

      Remove the 12 clips and cool air intake duct seal.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01EKOK

      Remove the 2 bolts and inlet air cleaner assembly.

  4. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01EIRR

      Remove the 4 bolts and No. 1 exhaust manifold heat insulator.

  5. REMOVE AIR FUEL RATIO SENSOR


    1. A01ELYB

      Disconnect the air fuel ratio sensor connector.

    2. Remove the wire harness clamp.

    3. A01EKKAE01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold.

      SST
      09224-00010