CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)


    1. Apply a light coat of engine oil to the O-ring of the sensor.

      Note

      Make sure that the O-ring is not cracked or does not jump out of position during installation.

    2. A01EJVYE06
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
    3. A01EJB5

      Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Connect the sensor connector.

  2. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)


    1. Apply a light coat of engine oil to the O-ring of the sensor.

      Note

      Make sure that the O-ring is not cracked or does not jump out of position during installation.

    2. A01EJVYE06
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
    3. A01EJWD

      Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Connect the sensor connector.

  3. INSPECT FOR OIL LEAK

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Fit the 3 retainers and install the No. 1 engine cover sub-assembly.