CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

    A01EJB5

    1. Disconnect the sensor connector.

    2. Remove the bolt and sensor.

  3. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

    A01EJWD

    1. Disconnect the sensor connector.

    2. Remove the bolt and sensor.