THROTTLE BODY REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    1. Remove the windshield wiper motor and link Click here.

  2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. A01EIQY

      Disengage the 2 clamps and separate the wiper wire harness from the outer cowl top panel sub-assembly.

    2. A01EKSW

      Disengage the 2 clamps and connector, and separate the wire harness from the outer cowl top panel sub-assembly (w/ Windshield Deicer).

    3. A01EL1AE01
      Text in Illustration
      *1 Bolt
      *2 Nut

      Remove the 4 bolts, 4 nuts and outer cowl top panel sub-assembly.

  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EK9G

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  4. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EJEH

      Remove the 12 clips and cool air intake duct seal.

  5. REMOVE NO. 1 ENGINE UNDER COVER

  6. REMOVE NO. 2 ENGINE UNDER COVER

  7. DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug and drain the coolant.

      Note

      Do not remove the reserve tank cap or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the radiator cap sub-assembly from the radiator assembly.

      A01EL4GE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug

  8. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY


    1. A01EM1H

      Disconnect the connector and 2 fuel vapor feed hoses.

    2. A01EJEL

      Remove the No. 1 vacuum switching valve assembly.

  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01EKFY

      Disconnect the mass air flow meter connector and separate the wire harness clamp from the air cleaner cap.

    2. Separate the hose from the hose clamp.

    3. A01EKWW

      Disconnect the ventilation hose from the cylinder head cover.

    4. A01EKRC

      Unlock the hose band and separate the air cleaner cap sub-assembly from the throttle body assembly.

    5. A01EJ98

      Remove the 2 bolts and air cleaner cap sub-assembly.

  10. REMOVE THROTTLE BODY ASSEMBLY


    1. A01EJO9

      Disconnect the throttle body assembly connector.

    2. Disconnect the fuel tube from the clamp.

    3. A01EKVP

      Disconnect the 2 water by-pass hoses from the throttle body assembly.

    4. A01EM4T

      Remove the 4 bolts and the throttle body assembly with the fuel tube bracket.

    5. A01EIXM

      Remove the bolt and fuel tube bracket.

    6. A01EJ9Y

      Remove the gasket from the intake manifold.