КОНТАКТНЫЙ ДАТЧИК ДАВЛЕНИЯ МАСЛА УСТАНОВКА


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01GJS4E19

      Apply adhesive to 2 or 3 threads of the switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    2. A01GNGV

      Using a 24 mm deep socket wrench, install the switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    3. Connect the switch connector.

  2. INSTALL NO. 1 ENGINE UNDER COVER


    1. Установите защиту картера двигателя № 1 и закрепите ее 13 винтами и 7 фиксаторами.

  3. INSPECT FOR ENGINE OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.