Click here

ТОПЛИВНЫЙ НАСОС СНЯТИЕ

Click here
Click here
  1. Click here

    PRECAUTION

    CAUTION:

    • Do not smoke or be near an open flame when working on the fuel system.

    • Keep gasoline away from rubber or leather parts.

    • Do not allow fuel to spray when removing the pipe between the high pressure side fuel pump and the fuel injector. The fuel in the pipe is highly pressurized.

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCHARGE FUEL SYSTEM PRESSURE

    (Click here)

  3. Click here

    REMOVE COWL TOP VENTILATOR LOUVER RH


    1. Расцепите 6 фиксаторов и снимите правую вентиляционную решетку в верхней части кожуха.

  4. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  5. Click here

    REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY


  6. Click here

    REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

    (Click here)

  7. Click here

    REMOVE REAR FLOOR NO. 2 SERVICE HOLE COVER


    1. Remove the service hole cover and disconnect the connector from the fuel suction with pump and gauge tube assembly.

  8. Click here

    REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. Disconnect the fuel main tube and fuel return tube.


      1. Remove the 2 tube joint clips and 2 fuel tubes.

        Note:

        • Remove any dirt and foreign matter on the fuel tube joint before performing this work.

        • Do not allow any scratches or foreign matter on the parts when disconnecting them, as the fuel tube joint contains the O-rings that seal the plug.

        • Perform this work by hand. Do not use any tools.

        • Do not forcibly bend, twist or turn the nylon tube.

        • Protect the disconnected part by covering it with a plastic bag and tape after disconnecting the fuel tubes.

    2. A01GIMC

      Remove the 8 bolts and set plate.

    3. A01GMKI

      Disconnect the fuel hose.

    4. Remove the fuel suction with pump and gauge tube from the fuel tank.

      Note:

      • Make sure that the sender gauge arm does not bend.

      • Do not damage the fuel suction with pump and gauge tube.

    5. Remove the gasket.