БЛОК ЦИЛИНДРОВ ЗАМЕНА


  1. REPLACE STRAIGHT PIN

    Note

    It is not necessary to remove the straight pin unless it is being replaced.


    1. Remove the straight pins.

    2. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

      A01GIHJE02
      Standard protrusion
      Item Specified Condition
      Pin A 23 mm (0.9055 in.)
      Pin B 11 mm (0.4331 in.)
      Pin C 9 mm (0.3543 in.)
      Pin D 6 mm (0.2362 in.)

  2. REPLACE STUD BOLT

    Note

    If a stud bolt is deformed or the threads are damaged, replace it.


    1. Remove the stud bolts.

    2. Using an E8 and E10 "TORX" socket wrench, install the stud bolts.

      A01GLS1E02
      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf, for Stud bolt A }
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf, for Stud bolt B }

  3. REPLACE TIGHT PLUG

    Note

    If water leaks from the tight plug or the plug corrodes, replace it.


    1. Remove the tight plug.

    2. A01GKV3E01

      Apply adhesive around the tight plug.

      Adhesive:
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    3. A01GNQEE01

      Using SST and a hammer, tap in the tight plug as shown in the illustration.

      SST
      09950-60010   ( 09951-00200 )
      09950-70010   ( 09951-07100 )